Tungsten Catalysts for Visible Light Driven Ofloxacin Photocatalytic Degradation and Hydrogen Production

Some tungsten catalysts of interest that are synthesized are bismuth tungstate (BT) and Tetrabutylammonium decatungstate (TBADT), using two consolidated procedures. BT is used as a photo-catalyst for the simulated solar light degradation of ofloxacin (OFL) antibiotic under relevant real conditions (µg L−1, fresh water) with the limit of 0.05 g L−1 of catalyst. A quantitative drug decomposition occurred following a bi-exponential first-order law, with an efficiency comparable with the most used P25 TiO2 catalyst. The photocatalytic profiles of OFL at µg L−1 and mg L−1 were monitored by high-pressure liquid chromatography (HPLC) coupled with fluorescence (FD) and ultraviolet (UV) detectors. Additionally, the main photoproducts were identified by high-pressure liquid chromatography coupled to electrospray ionization in tandem with mass spectrometry (HPLC-ESI-MS/MS). The catalyst Tetrabutylammonium decatungstate (TBADT) was used as a catalyst to produce hydrogen from glucose and 2-propanol in aqueous solution, providing hydrogen gas evolution up to 10 µmol g−1 h−1

HPLC-MS/MS multiclass determination of steroid hormones in environmental waters after preconcentration on the carbonaceous sorbent HA-C@silica

In this study, a sensitive and multiclass method has been developed for analysis of three families of steroid hormones, i.e. progestins, oestrogens, androgens, by SPE-HPLC-ESI-MS/MS. The extraction efficiency of thermally condensed humic acids onto silica sorbent (HA-C@silica), here for the first time studied for multiclass enrichment of these sex hormones, was tested in different environmental waters (tap and river water, urban wastewater treatment plant effluent) spiked at the nanograms per litre levels (5–1000 ng L−1). Quantitative adsorption was achieved using 200 mg sorbent for preconcentration of 250–1000 mL sample, at the native pH (pH = 6.5–7.7). Elution was performed by two sequential fractions (methanol followed by acetonitrile), obtaining in all the matrices investigated satisfactory recoveries (71% to 124% for river waters and 71–113% for urban wastewater treatment plant effluent) and RSDs below 15% (n = 3). The high enrichment factors (up to 4000) coupled with high-performance liquid chromatography tandem mass spectrometry quantification (MRM mode) provided low limits of detection and quantification (a few ng L−1), that are suitable for environmental monitoring. Most of the analytes were detected in river water and in wastewater effluent samples (in the ng L−1 concentration range), attesting their environmental diffusion. The proposed method was extended to a fourth class, Glucocorticoids, achieving good results in river samples, by the same SPE cartridge and chromatographic run. Keywords: Environmental waters, Steroid hormones, Multiclass determination, HPLC-MS, Pollutants, Solid-phase extractio

A Kinetic Approach to Photomineralization of Methane in Air by Membranes Based on TiO2/WO3

Photomineralization of methane in air (10.0-1,000 ppm (mass/volume) of C) at 100% relative humidity (dioxygen as oxygen donor), was systematically studied at 318 ± 3 K, in an annular laboratory-scale reactor, by photocatalytic membranes immobilising titanium dioxide and tungsten trioxide as co-photocatalysts. Kinetics of both substrate disappearance, to yield intermediates, and total organic carbon (TOC) disappearance, to yield carbon dioxide, were followed. A kinetic model was employed, from which, by a set of differential equations, four final optimised parameters, k1 and K1, k2 and K2, were calculated, able to fit the whole kinetic profile adequately. Modelling of quantum yields, as a function of substrate concentration and irradiance, as well as of concentration of photocatalysts, was carried out very satisfactorily. Kinetics of hydroxyl radicals reacting between themselves, leading to hydrogen peroxide, other than with substrate or intermediates leading to mineralization, were considered, paralleled by second competition kinetics involving superoxide radical anion. When using appropriate blends of the two photocatalysts, limiting quantum yields ∞ values increase considerably and approach the maximum allowable value for the investigated molecule, in a much wider range of irradiances than that shown by the single catalysts mainly at low irradiances. This may be interpreted by strong competition kinetics of superoxide radicals generated by the catalyst defects, in the corresponding range of high irradiances. By this way, operation at high irradiance values is possible, without losing any efficiency for the mineralization process

Solid-phase extraction of vanadium(V) from teainfusions and wines on immobilized nanometer titanium dioxide followed by ICP-OES analysis

Nanosized titanium dioxide immobilized on silica gel was synthesized and used as fixedbed phase for V(V) pre-concentration, followed by inductively coupled plasma optical emission spectroscopy (ICP-OES) analysis. Three different sorbents were prepared by sol\u2013gel method starting from a mixture of titanium isopropoxide, 2-propanol and water, and characterized by X-ray powder diffraction (XRPD), scanning electron microscopy (SEM) and BET analysis. V(V), the most stable and toxic oxidation state of the element, present in water and beverages samples, was selectively sorbed, pre-concentrated, quantitatively eluted by 0.1 M HCl and analyzed by ICP-OES. The effectiveness of the procedure was first assessed on tap water enriched with 1 lg L1 of V(V) obtaining recoveries up to 92% (n= 4). The pre-concentration step was then optimized for complex matrices such as tea infusions and red and white wines. The reliability of the procedure was assessed on the same beverages samples spiked with 20\u2013250 lg L1. Quantitative recoveries (82\u2013 95%, n= 4) were assured avoiding any sample pre-treatment, generally essential in such complex matrices, obtaining good precision (RSD< 12%, n= 3). The method was then applied to the determination of V(V) in commercial tea infusions and wines

Combined Layer-by-Layer/Hydrothermal Synthesis of Fe3O4@MIL-100(Fe) for Ofloxacin Adsorption from Environmental Waters

: A simple not solvent and time consuming Fe3O4@MIL-100(Fe), synthesized in the presence of a small amount of magnetite (Fe3O4) nanoparticles (27.3 wt%), is here presented and discussed. Layer-by-layer alone (20 shell), and combined layer-by-layer (5 shell)/reflux or /hydrothermal synthetic procedures were compared. The last approach (Fe3O4@MIL-100_H sample) is suitable (i) to obtain rounded-shaped nanoparticles (200-400 nm diameter) of magnetite core and MIL-100(Fe) shell; (ii) to reduce the solvent and time consumption (the layer-by-layer procedure is applied only 5 times); (iii) to give the highest MIL-100(Fe) amount in the composite (72.7 vs. 18.5 wt% in the layer-by-layer alone); (iv) to obtain a high surface area of 3546 m2 g-1. The MIL-100(Fe) sample was also synthesized and both materials were tested for the absorption of Ofloxacin antibiotic (OFL). Langmuir model well describes OFL adsorption on Fe3O4@MIL-100_H, indicating an even higher adsorption capacity (218 ± 7 mg g-1) with respect to MIL-100 (123 ± 5 mg g-1). Chemisorption regulates the kinetic process on both the composite materials. Fe3O4@MIL-100_H performance was then verified for OFL removal at µg per liter in tap and river waters, and compared with MIL-100. Its relevant and higher adsorption efficiency and the magnetic behavior make it an excellent candidate for environmental depollution

Physico-Chemical Features of Undoped and Fe/Cu-Doped Na0.67MnO2-Layered Cathodes for Sodium Batteries

Na0.67MnO2 (NMO) stands out among the layered cathode materials used for sodium batteries due to its high-capacity values, low cost, and environmental friendliness. Unfortunately, many drawbacks arise during cycling, but nanostructure tailoring and doping can help to mitigate them. Our aim was to synthesize undoped and Cu- or Fe-doped NMO samples via the sol-gel route, with a different cooling step to room temperature, i.e., in a natural way or via quenching. The formation of a mixture of polymorphs was observed, as well as differences in the external morphology of the powders' grains. The use of spectroscopic techniques, Mössbauer spectroscopy for the Fe-doped samples and Electron paramagnetic resonance, allowed us to gain insights into the oxidation states of transition metals and to make suggestions about the magnetic ordering, as well as on the possible presence of magnetic impurities. Cyclic voltammetry and galvanostatic cycling results were interpreted on the basis of the spectroscopic data: the introduction of substituents, in general, worsens the capacity values, due to the decrease in the P2 amount and the introduction of structural distortions. The structural stability of the samples in air as a function of time was also analyzed via X-ray diffraction, demonstrating the positive effect of Cu presence

Enhancement of TiO2 NPs Activity by Fe3O4 Nano-Seeds for Removal of Organic Pollutants in Water

The enhancement of the photocatalytic activity of TiO2 nanoparticles (NPs), synthesized in the presence of a very small amount of magnetite (Fe3O4) nanoparticles, is here presented and discussed. From X-ray diffraction (XRD) and differential scanning calorimetry (DSC) analyses, the crystallinity of TiO2 nanoparticles (NPs) seems to be affected by Fe3O4, acting as nano-seeds to improve the tetragonal TiO2 anatase structure with respect to the amorphous one. Photocatalytic activity data, i.e., the degradation of methylene blue and the Ofloxacin fluoroquinolone emerging pollutant, give evidence that the increased crystalline structure of the NPs, even if correlated to a reduced surface to mass ratio (with respect to commercial TiO2 NPs), enhances the performance of this type of catalyst. The achievement of a relatively well-defined crystal structure at low temperatures (Tmax = 150 \u25e6C), preventing the sintering of the TiO2 NPs and, thus, preserving the high density of active sites, seems to be the keystone to understand the obtained results

Current advances on the photocatalytic degradation of fluoroquinolones: photoreaction mechanism and environmental application

Heterogeneous photocatalysis is one of the most studied and promising techniques for degradation of contaminants of emerging concern, especially pharmaceuticals, and it represents a potential application in wastewater treatment of recalcitrant pollutants, such as fluoroquinolones, which are almost not abated by standard WWTPs. Although photodegradation partially contributes to alleviate their accumulation into the aquatic systems, heterogeneous photocatalysis assures complete sequestration and mineralization of FQs and their photoproducts and offers many advantages with respect to the other advanced oxidation processes (AOPs). The present brief review summarizes the most recent studies regarding the development and application of novel photocatalytic materials to the removal of FQs from contaminated waters. The collected data are arranged relating the mechanistic aspects to specific catalysts' properties, such as adsorption capacity, easy recovery, and reusability, especially under actual conditions.[GRAPHICS]